Launch X431 Diagnostic tool

Launch x431 key programmer specializes in reading and writing key information, generating various key chips, etc. Currently, it can only be used with X431 IMMO Elite , X431 IMMO Plus , X431 PAD V (PAD 5), and X431 PAD VII (PAD 7) . How to use the x431 key programmer? 1. Use with Super Chips On the tablet (this item uses PAD V as an example), open the X431 PAD V APP, select "Other Modules" >> "Toolbox" >> "Key Programming" Enter the "Set Super Chip Type" menu to generate. Select the corresponding key chip type and insert the super chip into the anti-theft induction coil. Once successfully generated, it can be used. 2. Use with Super Remotes Take LS Nissan super remote as an example: The initial operation is the same as the super chip, enter the "Key Programming" menu and select "Vehicle Remote", then select the corresponding smart key model to generate. Place the electronic remote key in the key programmer to gener...

This is a tutorial on how to use Launch X431 G3 + X-PROG PC Adapter to clone Volkswagen MED17.5.25 ECU on bench. By connecting with the PC adapter, G3 can work as X431 ECU & TCU Programmer to read and write ECU data. Read also: Launch X-431 ECU & TCU Programmer vs. GIII X-PROG3 Connection 1. Open X-PROG3 PC Adaptor software, enter ECU model to search, and select: Volkswagen(VW), Beetle 2011-2017, CYVD 1197 104, MED17.5.25 TC1782F 320 2. Click "Direct connection of diagram" to get the wiring diagram for the connection. Procedure 1. Backup Original ECU Data Click "Read chip ID". Read EEPROM data >> Save EEPROM data file Read FLASH data >> Save FLASH data Disconnect. 2. Data Processing Go back to the previous interface Data processing >> Data cloning >> VW MEDC17 clone >> Load the FALSH file of the original ECU >> Load the EEPROM file of the original ECU >> Load the FLASH file of the external ECU >> Load the EE...

This is a tutorial on how to clone 2007 Audi A4 VL381 with Launch X-431 ECU & TCU Programmer on bench. Read this article to learn how easy and fast to do. Step1. ECU Connection Connect X-431 ECU & TCU Programmer to PC. Enter ECU model to search >> Selected the corresponding make, model, engine and ECU(2007 Audi A4, ALT 2000 130 engine, VL381 TC1766 ECU) >> Direct connection diagram Follow the diagram to connect with Audi gearbox. Step2. ECU Clone Connect >> Read EEPROM data >> Save EEPROM data. Read FLASH data >> Save FLASH data. Write EEPROM data >> Load the saved EEPROM data file Writing till...100%. Write FLASH data >> Load the saved FLASH data file Writing till...100%. Data is successfully written. Audi gearbox clone has been done. Do not forget to click "Disconnect" before leaving. www.obd2shop.co.uk